| Details | - Easy wiring and small installation size (66 x 66 mm)
- With start delay
- All inputs are switched to earth
| |
|---|
| Application range | - For industrial use on mobile and stationary machines
- For monitoring oil pressure, temperature, dynamo charging etc.
- For water pumps, power units, compressors, joint cutters, bush hammers and choppers
- For cooling, heating and hydraulic equipment
- For tractors, trucks, construction and agricultural machinery
| |
|---|
| Properties | - Inputs for oil-pressure switches, temperature switches, dynamo D+, dynamo W, stop-in and auxiliary port, e.g. for water pump pressure switch
- Outputs for solenoid switches, 40 A induction coil and 3.5 A stop coil, alarm, switching voltage (15) and start (50)
- Errors are stored and indicated with a red LED
- After an error has occurred the engine is switched off after 3 seconds and the external output is activated
- If the same error occurs more than once and for more than 3 seconds in total, the engine will be switched off subsequently
- If no more active errors occur within 10 seconds, the memory contents will be deleted
- Other inputs will be locked, so the source of the error can be found at any time
- During normal operation the engine can be switched off at any time
- Assembly with vibration dampers or U-brackets
| |
|---|
| Technical info | - The sensors specified in the diagram must be used
- Attention: keyswitch position 1 has a test function
- Use position 2 (short term) to activate engine protection
- If position 2 is not used, the engine will switch off after 6 seconds
| |
|---|
| Benefits | - Easy to install
- A bypass switch is not required
- User friendly
| |
|---|
